Belkin Marine Instruments F6C350 SER SB User Manual

INTRODUCTION  
BATTERY REPLACEMENT  
BATTERY REPLACEMENT (CONTINUED)  
Thank you for participating in the Belkin EcoPower Battery  
Replacement Program™. Our program ensures that you receive the  
correct battery for your UPS and your used battery is properly  
recycled. Save the boxes and packaging material that your  
replacement battery came in. You will need it to return your used  
battery.  
Self-Test  
Use the self-test to verify both the operation of the UPS and the  
condition of the battery. In normal utility power, push the  
“On/Off/Test” button less than two seconds and the UPS performs  
a self-test function. During the self-test, the UPS operates in  
“back-up” mode.  
®
Note:  
WARNING  
Step 6: Put the battery cover back and slide it into position.  
Step 7: Connect your computer cords into the unit.  
ECOPOWER BATTERY  
REPLACEMENT  
During the self-test, the UPS briefly operates “on battery” mode (the  
“Replace Battery” LED comes on). If the UPS passes the self-test, it  
returns to “On Line” operation. The “Replace Battery” LED goes off  
and the “On Line” LED goes on steady. If the UPS fails the self-test it  
immediately returns to on-line operation and flashes the “Replace  
Battery” LED. The loads are not affected. Recharge the battery  
overnight and perform the self-test again. If the “Replace Battery”  
LED is still on, the battery will need to be replaced; go to belkin.com.  
Warning! Before replacing your battery, please review this manual in  
its entirety. If you have any issues, are technically challenged, have a  
difficult time following instruction manuals or you cannot program  
your VCR, STOP IMMEDIATELY, and contact Belkin Technical Support  
at: (800) 223-5546 ext. 2263 or refer to a qualified computer  
professional for assistance.  
Step 8: Turn on UPS unit by depressing and holding down the  
On/Off/Test button.  
INSTRUCTION MANUAL  
FOR MODELS  
F6C350-SER-SB  
F6C500-SER-SB  
F6C650-SER-SB  
BATTERY RETURN INSTRUCTIONS  
You should have received the following:  
1. 1 Battery  
Additional recycling information is provided with your new battery  
Silence  
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL OR  
CONTACT BELKIN COMPONENTS.  
2. EcoPower Instruction Manual  
3. UPS Call Tag Label  
In " BACK-UP" mode, push the On/Off/Test button less than three  
seconds to silence the audible alarm. (The function is void when  
under condition of "Low Battery".)  
Battery Return Instructions  
Step 1: Turn off your UPS by depressing and holding the  
On/Off/Test button for more than 3 seconds until the “On  
Line” or “On Battery” indicator light goes off. You will hear  
a beep when your unit shuts off.  
Step 1: Insert used battery into small box and seal with  
FRONT PANEL  
P74075  
packaging tape.  
Step 2: Place the boxed battery inside the bigger box. Please be  
sure to cover the smaller box with the packing material. Seal the box  
with packaging tape.  
Fault/Overload  
Low Battery/Replace Battery  
Step 2: Disconnect EVERY cord from your Belkin UPS.  
Step 3: Peel off the return label and place it onto the top of the box.  
Step 4: Drop at UPS shipping center or UPS drop-off location.  
On Line/On Battery  
On/Off/Test  
Step 3: Lay down the UPS. Use your thumb to open the battery  
cover on the bottom of the unit.  
WARRANTY  
One-year warranty on battery. Additional warranty programs available.  
Please check belkin.com for updated information.  
Belkin Components USA  
800.223.5546  
800.2BELKIN  
Step 4: Grasp the tab attached to the battery and slide the battery out.  
Belkin Components  
501 West Walnut Street  
Compton • CA • 90220 • USA  
Tel: 310.898.1100  
OPERATION  
Fax: 310.898.1111  
Belkin Components, Ltd.  
Unit 13 • Gatelodge Close  
Switch On  
Round Spinney • Northampton • Northants  
NN3 8RX • United Kingdom  
Tel: +44 (0) 1604678300  
With the UPS plugged in, press and hold the On/Off/Test button for  
more than three seconds until the "On Line" LED lights up to switch  
the UPS on. The UPS will perform self-testing each time it is  
switched on. Note: The UPS maintains the battery charge when in the  
off position.  
Fax: +44 (0) 1604678330  
Step 5: Insert the replacement gently into the UPS. Make sure the battery  
Belkin Components, Ltd.  
is well connected!  
7 Bowen Cresent • West Gosford • NSW 2250 • Australia  
Tel: +61 (2) 4372 8600  
Fax: +61 (2) 4325 4277  
Switch Off  
Press and hold the On/Off/Test button for more than three seconds  
until the "On Line" or "On Battery" LED goes off.  
© 2001 Belkin Components. All rights reserved. All trade names are  
registered trademarks of respective manufacturers listed.  
 

Black Box Computer Monitor LE2801A User Manual
Black Decker Blender BX700G User Manual
Black Decker Cordless Drill CD632 User Manual
Bush Hog Compact Loader FC 0014 User Manual
Campbell Hausfeld Automobile AT121102AJ User Manual
Canon Projector DC 4381 User Manual
Casio Electronic Keyboard LK300AR1A User Manual
Char Broil Smoker 11101625 User Manual
Chief Manufacturing Indoor Furnishings FHP 110 User Manual
Chip PC Computer Hardware CDC01927 User Manual